.

.

.

 Oil Forensics» 

Case studies available:

 » GRO in Soil

 » EDRO in Soil

 » EPH in Soil

 » PAHs in Soil

 » TPH O&G in Soil

 » TPH in Water

 » Oil Forensics Analysis

 » TPH Fingerprinting

 » Oil on Metal Surfaces

 » TD-500D Applications

 » UVF Training Courses

 

 Home Page»

 What's New?»

 Products & Rentals»

 Lab Services»

 Case Studies»

 UVF Technology»

 EPA Performance»

 Test Procedures»

 Contact Us»

 

 
 
 
 
Sitelab NAPL maps constructed using Surfer...Click here for details!
 

 

 

 
 
 

 

In addition to soil and water, oil samples can also be tested to identify the type or age of petroleum.  Samples are extracted and diluted in solvent and then measured on the UVF for GRO, EDRO or PAH content.  The equipment is easy to use.  Samples take just a few minutes to analyze.  Fingerprinting instructions and training by phone is included with Sitelab UVF-3100D purchase or rental orders. 

  

 

Petroleum Tank Farm Site with NAPL

Sitelab's mobile laboratory was used by an environmental engineering firm to test Non Aquous Phase Liquids (NAPL) collected from 40 monitoring wells for their gasoline range and diesel range content.  The site is located along Boston Harbor and once supplied diesel and heavy fuel oil to the region.  The data mapped by the client shows how the oils fluoresced, which helped the client design a recovery system.        

 

See case study

 

 

Refinery Site with Commingled Oil Plume

An environmental consultant used Sitelab to help dilineate a 100-acre size plume of NAPL at a former oil refinery in Kansas.  Samples collected from 35 monitoring wells were measured for their GRO and DRO content using the UVF-3100D analyzer.  Ratios exhibited in the data show where and what type of contamination exists below the ground.      

  See case study

 

Crude Oil Production Wells

An oil company in Oklahoma used Sitelab’s laboratory to perform oil forensic analysis testing crude oils from different well sites to determine the percentage of oil content from two formations.  The wells tap into the Mississippi and Chester formations at different depths, thousands of feet deep.  Knowing what type of oil being pumped up is important.  Screening oils on-site using ultraviolet fluorescence is a fast and cost effective tool.  

  See case study

 

Produced Water Treatment Site

A pilot study was performed testing samples contaminated with produced water from several oil well production sites in Wyoming.  The client provides mobile water treatment systems that enable oil and gas companies to recycle and reuse flow back water more efficiently.  Ratios exhibited in the results provides helpful information about the type of oil being treated at each site.     

 

  See case study


 

Learn more about TPH Fingerprinting...

                                           -

  Welcome to site-lab.com!     HOME   I   WHAT'S NEW   I   PRODUCTS & SERVICES   I  CASE STUDIES   UV FLUORESCENCE   I  TEST PROCEDURES   I  CONTACT US

© 2016  Sitelab Corporation   USA   All Rights Reserved      site-lab.com      Sitelabcorp.com     SitelabCorporation.com